This is a 'Firmware Upgrade Project' for the Equinox FS2009 programmer.
Programmer: FS2009 Upgrade to firmware version: 5.36 Release date: 27th July 2010
New features in this version:
Algorithms supported in this version:
- Atmel AVR - SPI interface
- Atmel AVR - JTAG interface
- Atmel AT89C51Rxx - 8051 UART programmable devices
- Atmel AT91SAM7 - JTAG interface
- Atmel AT89Sxxxxx - SPI interface
- NXP - 89C51Rxx - 8051 UART programmable devices
- Zensys ZWxxx Series - SPI interface
Algorithms NOT supported in this version:
- All silicon vendors - generic 24xxx I2C serial EEPROM memories
If you require support for I2C programming of Serial EEPROM devices, please contact Equinox and we will send you a special version of firmware which supports these devices.
Problem corrections:
1. AVR Fuse Write / Verify did not work in standalone mode The Fuse Write / Verify operation for Atmel AVR devices did not work in standalone mode in firmware 5.34. This problem is fixed in firmware 5.36.
2. AVR Calibration Byte problem in standalone mode If the 'AVR Calibration Byte' was set to be programmed into the FLASH in standalone mode, the 'Calibration Byte' would be written to the wrong address. This problem is fixed in firmware 5.36.
Firmware installation instructions:
- Unzip the attached *.PPC file
- Check which version of the Epsilon5 programmer you have by selecting .
- Use EQTools or Upload Wizard to upload the correct 'Firmware upgrade PPC file' to the programmer.
- The programmer will then automatically re-flash its firmware.
Further help:
For further help with upgrading your programmer firmware, please refer to Application Note AN112. |