This is a 'Firmware Upgrade Project' for the Equinox FS2003 programmer.
Programmer: FS2003
Upgrade to firmware version: 5.37A (standard device support)
Release date: 8th December 2011
Features:
- Problem with 'Programmer Credits' corrupting 'Programmer license info' has been fixed.
- Various updates to JTAG algorithms to improve speed and reliability
- Exit JTAG functionality has been enhanced to always perform a full 'Exit JTAG' sequence at the end of every standalone project.
Algorithms supported in this version:
- Atmel AVR - SPI interface
- Atmel AVR - JTAG interface
- Atmel AT89Sxxxxx - SPI interface
- Atmel / Temic - AT89CRxx - UART interface
- NXP P89C51Rx2 - UART interface
- Zensys Z-WAVE - SPI interface
- All silicon vendors - generic 24xxx I2C serial EEPROM memories
Algorithms NOT supported in this version:
- Atmel ARM7 - JTAG interface
Instructions:
- Unzip the attached *.PPC file
- Use EQTools or Upload Wizard to upload the PPC file to the programmer.
- The programmer will then automatically re-flash its firmware.
Further help:
For further help with upgrading your programmer firmware, please refer to Application Note AN112. | 
Compressed File (*.zip)
